
Stronger joints without a patchwork finish
Loose mortar removed
We cut out defective material rather than covering weak joint faces.
Mortar carefully matched
Colour, texture and strength are considered against existing masonry.
Joints finished neatly
A consistent profile improves appearance and helps shed rainwater.
Replace failing mortar before joints open further
Mortar holds the face of a wall together while helping it cope with weather. When joints crack, loosen or wear back, they leave the edges of the bricks more exposed and can let moisture into the masonry. Warning signs include powdering mortar, visible gaps, local dampness and small pieces falling from the wall. We inspect the affected elevation and the condition of the bricks before deciding how much mortar needs attention. Repointing at the right time can restore closed, weather-resistant joints without waiting for larger areas to fail. It also removes the patchy look created by deep shadows and crumbling lines between sound bricks.


Use mortar that works with the existing wall
Proper repointing involves removing defective mortar to a suitable depth and cleaning the joints so the replacement can bond. We then install new mortar with attention to its strength, colour and texture. A mix that is too hard or visually mismatched can work against the original masonry or leave an obvious grid across the elevation. Joint profile and neat finishing affect how rain sheds and how the wall looks at normal viewing distance. Controlled curing matters too, because mortar needs suitable conditions as it sets. We bring wider masonry and rendering knowledge to the job, which helps where failed joints sit beside other exterior defects.
Frequently asked questions
How can I tell if brickwork needs repointing?
Look for mortar that powders when touched, cracks, open joints, damp patches or loose pieces below the wall. We can assess whether the wear is isolated or affects a wider elevation before defining the repointing area.
Does old mortar need removing before repointing?
Yes, defective mortar should be removed to a suitable depth. The joints then need cleaning before replacement mortar is installed. Applying a thin layer over loose material will not provide the same sound bond.
Why does the replacement mortar need careful selection?
Mortar strength should work with the existing brickwork, while colour and texture affect the final appearance. We consider all three so the new joints do not form an unsuitable or glaringly different patch.
